Difference between revisions of "Gigabot Kit"
From re:3D
Line 15: | Line 15: | ||
[[File:GB2_full_kit_Manual.jpg|300px|none]] | [[File:GB2_full_kit_Manual.jpg|300px|none]] | ||
Older - GB2 - [[File:Parts_Kit_Box_Opening_Guide_v1.pdf]] | Older - GB2 - [[File:Parts_Kit_Box_Opening_Guide_v1.pdf]] | ||
+ | |||
+ | == Gigabot Wiring Diagrams == | ||
+ | |||
+ | [http://wiki.re3d.org/images/7/7f/GigaBot_sys_drw_V1.0.pdf Viki 1.0 and Azteeg 1.0] | ||
+ | |||
+ | [http://wiki.re3d.org/images/8/84/GigaBot_sys_drw_V1.2.pdf Viki 2.0 and Azteeg 1.2] | ||
+ | |||
+ | [http://wiki.re3d.org/images/f/fa/GigaBot_sys_drw_V2.0.pdf Viki 2.0 and Azteeg 2.0] | ||
+ | |||
+ | [http://wiki.re3d.org/images/8/89/Filament_Detection_Wiring_Diagram.pdf Filament Detection] | ||
==Installing software and printing== | ==Installing software and printing== |
Revision as of 21:05, 14 December 2015
Contents
Assembly
Gigabot kit instructions guides are here:
[GB3 running edit log for kit instructions until revised editions can be made]
[GB3 Panduit sizing and placement list]
[GB3 Kit Part Unboxing List and Snappy Box Contents]
Older - GB2 - File:Parts Kit Box Opening Guide v1.pdf
Gigabot Wiring Diagrams
Installing software and printing
- Installing and using software with Gigabot
- Firmware installation
- Calibrating your Gigabot
- Applying BuildTak print surface
- First Print