Difference between revisions of "Fully Assembled Gigabot"

From re:3D
Jump to: navigation, search
(Installing software and start printing)
Line 9: Line 9:
#[[Installing and using software with Gigabot]]
#[[Installing and using software with Gigabot]]
#[[Firmware installation]]
#[[Calibrating your Gigabot]]
#[[Calibrating your Gigabot]]
#[[First Print]]
#[[First Print]]

Revision as of 17:00, 26 January 2016

Fully assembled Gigabot

Opening the crate and setting up your Gigabot

  1. Inspect the exterior of the crate for any visible damage
  2. Inspect the Tip-n-Tell indicators on two sides of the crate
  3. Inspect Shockwatch indicator on the outside of the crate

Installing software and start printing

  1. Installing and using software with Gigabot
  2. Calibrating your Gigabot
  3. First Print

Getting the most from your Gigabot

  1. Getting a good print
  2. Printing from Gigabot's Viki controller
  3. Tuning hot-end temperature controller
  4. Changing the filament spool
  5. Gigabot maintenance schedule