Difference between revisions of "Gigabot maintenance schedule"

Revision as of 12:19, 31 July 2014

Perform a general inspection of the wiring, belts, print head and print surface.

After the initial 20 hours of print time:

Inspect the X and Y belts for proper tension. Belts are, in general, rated to yield a minimum of 3000 hours of useful life.

Inspect V-groove wheels are properly tensioned and no free play is found between the trolley, gantry or bed platform and the Makerslide rails.

Once a week:

Inspect the X and Y axis Makerslide and roller wheels for dirt and debris. Wipe with a clean cloth and alcohol to remove dirt build-up.

Check Z axis threaded rods have plenty of grease lubricant.

After every 500 hours of print time –

Replace the Hot-end

Inspect belt tension

Inspect extruder gears for wear.

Expected lifetime of moving / wearable items:

Extruder= 1500-2000 hrs

Belts = 3000 hrs

Wheel bearings:

X and Y axis = 6000 hrs

Z axis = >6000 hrs

Z axis lift nuts = 5000 hrs

@@ Line 1: / Line 1: @@
 ===Proper use and maintenance of your machine will ensure a long and productive life===
-====Each time you use your Gigabot====
+=====Each time you use your Gigabot=====
 :Perform a general inspection of the wiring, belts, print head and print surface.