Difference between revisions of "Tuning hot-end temperature controller"

From re:3D
Jump to: navigation, search
(Created page with "=To fine-tune the hot-end PID control loop= With the extruder cooled off: In Pronterface type into the data entry box at the lower right corner “M303 S195”. This will sta...")
 
(→‎To fine-tune the hot-end PID control loop)
Line 1: Line 1:
−
=To fine-tune the hot-end PID control loop=
+
 
 
With the extruder cooled off:
 
With the extruder cooled off:
  

Revision as of 22:57, 4 August 2014

With the extruder cooled off:

In Pronterface type into the data entry box at the lower right corner “M303 S195”. This will start the PID auto-tune function in the Marlin Firmware. It will cycle the heat up and down several times until displaying the message: PID Autotune Complete Read the last set of output values given

Classic PID
Kp: 50.03
Ki: 1.98
Kd: 150.98

Copy these values on a piece of paper.

In Pronterface disconnect from Gigabot

Close Pronterface

Restart Pronterface

Connect to Gigabot

In Pronterface type into the data entry box at the lower right corner: 

	M301 P(your Kp value) I(your Ki value) D(your Kd value)

It should look like this using the example above: M301 P50.03 I1.98 D150.98

This will change the current settings for the temperature controller.

Set hot-end temperature to 195 and watch that it comes up to temp, overshoots the target temp slightly, undershoots temp slightly and then settles onto the target temp within 1-2 deg C.

These kp, ki and kd values should be copied and pasted into the start g-code in Slic3r

Slic3r -> Printer Settings -> Custom G-code -> Start G-code

Retrieved from "http://wiki.re3d.org/index.php?title=Tuning_hot-end_temperature_controller&oldid=6063"