All public logs
Combined display of all available logs of re:3D. You can narrow down the view by selecting a log type, the username (case-sensitive), or the affected page (also case-sensitive).
- 15:53, 16 February 2015 Matthew (Talk | contribs) automatically marked revision 6513 of page File:Gigabot Slic3r config.ini patrolled
- 15:52, 16 February 2015 Matthew (Talk | contribs) automatically marked revision 6512 of page File:Gigabot Slic3r config.ini patrolled
- 15:09, 14 July 2014 Matthew (Talk | contribs) uploaded a new version of "File:Gigabot Slic3r config.ini" (Support threshold angle from 90 -> 0. Infill from 25% -> 20% Cooling slowdown time from 12 -> 20 seconds)
- 14:32, 5 July 2014 Matthew (Talk | contribs) uploaded a new version of "File:Gigabot Slic3r config.ini" (increased from 1->2 perimeters perimeters from inside to out reduced rapid travel rate from 150 to 100mm/sec reduced hot-end temp to 195C changed X and Y M92 calibration to 118.54 changed Z M92 calibration to 4031.5 added M201 X1500 Y1500)
- 19:28, 27 June 2014 Gerty (Talk | contribs) uploaded a new version of "File:Gigabot Slic3r config.ini"
- 23:31, 20 December 2013 Admin (Talk | contribs) uploaded "File:Gigabot Slic3r config.ini"