Difference between revisions of "Moving Gigabot through a doorway"
From re:3D
Line 5: | Line 5: | ||
To remove the lower front frame cross-bar | To remove the lower front frame cross-bar | ||
− | [[File:Crossbar.jpg| | + | [[File:Crossbar.jpg|center|900px]] |
− | + | #Loosen the M5 x 12 bolt securing the inside corner brace (both right and left side) | |
− | [[File:Step1.jpg| | + | [[File:Step1.jpg|center|900px]] |
− | + | #Loosen three M5 x 8 bolts on the outside corner brace (both right and left side) | |
− | [[File:Step2.jpg| | + | [[File:Step2.jpg|center|900px]] |
− | + | #Remove two M5 x 12 bolts attaching the side plate to the frame (both right and left side) | |
− | [[File:Step3.jpg| | + | [[File:Step3.jpg|center|900px]] |
− | + | #Slide the lower frame piece down with the outside corner braces still attached |
Revision as of 16:29, 23 October 2014
How to pass Gigabot through a doorway less than 34" wide
Move Gigabot's bed up to or near the home position.
To remove the lower front frame cross-bar
- Loosen the M5 x 12 bolt securing the inside corner brace (both right and left side)
- Loosen three M5 x 8 bolts on the outside corner brace (both right and left side)
- Remove two M5 x 12 bolts attaching the side plate to the frame (both right and left side)
- Slide the lower frame piece down with the outside corner braces still attached