Difference between revisions of "Moving Gigabot through a doorway"
From re:3D
| Line 5: | Line 5: | ||
To remove the lower front frame cross-bar | To remove the lower front frame cross-bar | ||
| − | [[File:Crossbar.jpg|center| | + | [[File:Crossbar.jpg|center|800px]] |
| − | + | Loosen one M5 x 12 bolt and remove one M5 x 12 bolt securing the inside corner brace (both right and left side) | |
| − | [[File:Step1.jpg|center| | + | [[File:Step1.jpg|center|800px]] |
| − | + | Loosen three M5 x 8 bolts on the outside corner brace (both right and left side) | |
| − | [[File:Step2.jpg|center| | + | [[File:Step2.jpg|center|800px]] |
| − | + | Remove two M5 x 12 bolts attaching the side plate to the frame (both right and left side) | |
| − | [[File:Step3.jpg|center| | + | [[File:Step3.jpg|center|800px]] |
| − | + | Slide the lower frame piece down with the outside corner braces still attached | |
Revision as of 16:31, 23 October 2014
How to pass Gigabot through a doorway less than 34" wide
Move Gigabot's bed up to or near the home position.
To remove the lower front frame cross-bar
Loosen one M5 x 12 bolt and remove one M5 x 12 bolt securing the inside corner brace (both right and left side)
Loosen three M5 x 8 bolts on the outside corner brace (both right and left side)
Remove two M5 x 12 bolts attaching the side plate to the frame (both right and left side)
Slide the lower frame piece down with the outside corner braces still attached
