Difference between revisions of "Moving Gigabot through a doorway"
From re:3D
| Line 7: | Line 7: | ||
[[File:Crossbar.jpg|left|900px]] | [[File:Crossbar.jpg|left|900px]] | ||
| − | + | ;Loosen the M5 x 12 bolt securing the inside corner brace (both right and left side) | |
[[File:Step1.jpg|left|900px]] | [[File:Step1.jpg|left|900px]] | ||
| − | + | ;Loosen three M5 x 8 bolts on the outside corner brace (both right and left side) | |
[[File:Step2.jpg|left|900px]] | [[File:Step2.jpg|left|900px]] | ||
| − | + | ;Remove two M5 x 12 bolts attaching the side plate to the frame (both right and left side) | |
[[File:Step3.jpg|left|900px]] | [[File:Step3.jpg|left|900px]] | ||
| − | + | ;Slide the lower frame piece down with the outside corner braces still attached | |
Revision as of 16:28, 23 October 2014
How to pass Gigabot through a doorway less than 34" wide
Move Gigabot's bed up to or near the home position.
To remove the lower front frame cross-bar
- Loosen the M5 x 12 bolt securing the inside corner brace (both right and left side)
- Loosen three M5 x 8 bolts on the outside corner brace (both right and left side)
- Remove two M5 x 12 bolts attaching the side plate to the frame (both right and left side)
- Slide the lower frame piece down with the outside corner braces still attached
