Gigabot revision history
From re:3D
Contents
Mechanical
Early Kickstarter machines
Machine numbers 002 to 024
Topside filament spool
12 volt system
Single Fan hole in electrical box right side
Later Kickstarter machines
Machine numbers x to x
Filament spool lowered
24 volt electrical system
Single Fan hole in electrical box bottom side
Firmware changes from 3.1
- define INVERT_X_DIR true
- define INVERT_Y_DIR true
- define INVERT_Z_DIR false
- define INVERT_E0_DIR true
Post Kickstarter machines
Machine numbers x to x
Dual fan holes in electrical box right and bottom sides
Firmware changes from 3.2 to 3.3
Configration.h:
- line 145 #define TEMP_SENSOR_BED -1 (was #define TEMP_SENSOR_BED 0)
- line 181 #define PID_MAX 255 (was #define PID_MAX 127)
- line 331 #define min_software_endstops false (was #define min_software_endstops true)
- line 363 #define .... {118.4,118.5,4029.9,1850} (was #define DEFAULT_AXIS_STEPS_PER_UNIT {118.4,118.5,4029.9,1701})
Configration_adv.h
- line 18 #define WATCH_TEMP_PERIOD 40000 (was commented out)
- line 19 #define WATCH_TEMP_INCREASE 10 (was commented out)
- line 58 #define TEMP_SENSOR_AD595_OFFSET 9.0 (MJF)
- line 59 #define TEMP_SENSOR_AD595_GAIN 1.45 (MJF)
Pins.h
- line 2164 #define TEMP_BED_PIN 11 (was #define TEMP_BED_PIN 1)