Difference between revisions of "Firmware installation"
From re:3D
(→Software) |
(→Software) |
||
Line 5: | Line 5: | ||
*Non heated bed. [https://www.dropbox.com/s/swq88e15t8apb6b/Marlin%20Gigabot%20KS3.1.zip Download version (V3.1)] | *Non heated bed. [https://www.dropbox.com/s/swq88e15t8apb6b/Marlin%20Gigabot%20KS3.1.zip Download version (V3.1)] | ||
− | *Heated bed: [https://www.dropbox.com/s/np6xqlho2i5vf2z/Marlin-Gigabot3.3.zip Download version (V3.3)] | + | *Heated bed: [https://www.dropbox.com/s/np6xqlho2i5vf2z/Marlin-Gigabot3.3.zip Download version (V3.3)] |
+ | |||
− | You will also need the supporting libraries for the LCD display: [https://www.dropbox.com/s/48pglte86cgi2sm/Arduino%20Sketchbook.zip Arduino Sketchbook.zip] | + | You will also need to download the supporting libraries for the LCD display here: [https://www.dropbox.com/s/48pglte86cgi2sm/Arduino%20Sketchbook.zip Arduino Sketchbook.zip] |
===Configuring and compilation=== | ===Configuring and compilation=== |
Revision as of 21:48, 4 August 2014
Software
We recommend using Arduino IDE version 1.0.5 to load the firmware into Gigabot's brain (aka Azteeg X3 controller board).
There are two versions of the firmware:
- Non heated bed. Download version (V3.1)
- Heated bed: Download version (V3.3)
You will also need to download the supporting libraries for the LCD display here: Arduino Sketchbook.zip
Configuring and compilation
- Install the Arduino software
- Unzip the Arduino Sketchbook.zip
- Open Arduino and go to File-> Preferences. Under "Sketchbook Location" click on Browse. Navigate to the Arduino Sketchbook folder you unzipped above
Start the arduino IDE. Select Tools -> Board -> Arduino Mega 2560 or your microcontroller Select the correct serial port in Tools ->Serial Port Open Marlin.pde
Click the Verify/Compile button
Click the Upload button If all goes well the firmware is uploading