Difference between revisions of "File:Gigabot Slic3r config.ini"
From re:3D
(Matthew uploaded a new version of "File:Gigabot Slic3r config.ini": Support threshold angle from 90 -> 0. Infill from 25% -> 20% Cooling slowdown time from 12 -> 20 seconds) |
|||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
− | + | IMPORTANT*** Right click on the above file and choose "Save Link As". Save the file in a place you can easily access such as your desktop. |
Latest revision as of 15:53, 16 February 2015
IMPORTANT*** Right click on the above file and choose "Save Link As". Save the file in a place you can easily access such as your desktop.
File history
Click on a date/time to view the file as it appeared at that time.
Date/Time | Dimensions | User | Comment | |
---|---|---|---|---|
current | 15:09, 14 July 2014 | (3 KB) | Matthew (Talk | contribs) | Support threshold angle from 90 -> 0. Infill from 25% -> 20% Cooling slowdown time from 12 -> 20 seconds |
14:32, 5 July 2014 | (3 KB) | Matthew (Talk | contribs) | increased from 1->2 perimeters perimeters from inside to out reduced rapid travel rate from 150 to 100mm/sec reduced hot-end temp to 195C changed X and Y M92 calibration to 118.54 changed Z M92 calibration to 4031.5 added M201 X1500 Y1500 | |
19:28, 27 June 2014 | (3 KB) | Gerty (Talk | contribs) | ||
23:31, 20 December 2013 | (3 KB) | Admin (Talk | contribs) |
- You cannot overwrite this file.
File usage
There are no pages that link to this file.