Difference between revisions of "File:Gigabot Slic3r config.ini"
From re:3D
(Matthew uploaded a new version of "File:Gigabot Slic3r config.ini": Support threshold angle from 90 -> 0. Infill from 25% -> 20% Cooling slowdown time from 12 -> 20 seconds) |
|||
| Line 1: | Line 1: | ||
| − | + | TEST | |
Revision as of 15:52, 16 February 2015
TEST
File history
Click on a date/time to view the file as it appeared at that time.
| Date/Time | Dimensions | User | Comment | |
|---|---|---|---|---|
| current | 15:09, 14 July 2014 | (3 KB) | Matthew (Talk | contribs) | Support threshold angle from 90 -> 0. Infill from 25% -> 20% Cooling slowdown time from 12 -> 20 seconds |
| 14:32, 5 July 2014 | (3 KB) | Matthew (Talk | contribs) | increased from 1->2 perimeters perimeters from inside to out reduced rapid travel rate from 150 to 100mm/sec reduced hot-end temp to 195C changed X and Y M92 calibration to 118.54 changed Z M92 calibration to 4031.5 added M201 X1500 Y1500 | |
| 19:28, 27 June 2014 | (3 KB) | Gerty (Talk | contribs) | ||
| 23:31, 20 December 2013 | (3 KB) | Admin (Talk | contribs) |
- You cannot overwrite this file.
File usage
There are no pages that link to this file.
