Difference between revisions of "Viki installation"
From re:3D
| (One intermediate revision by the same user not shown) | |||
| Line 9: | Line 9: | ||
...and use our PDF instruction manual: | ...and use our PDF instruction manual: | ||
[[Image:Viki_2_Manual.jpg|thumb|none|top|500px|link=http://wiki.re3d.org/images/8/8a/Re3D_Viki_2_Full_10-21-2015.pdf]] | [[Image:Viki_2_Manual.jpg|thumb|none|top|500px|link=http://wiki.re3d.org/images/8/8a/Re3D_Viki_2_Full_10-21-2015.pdf]] | ||
| + | |||
| + | |||
| + | |||
| + | '''Upgrading from a Viki 1 to a Viki 2 requires you to install new [http://wiki.re3d.org/index.php?title=Firmware_installation firmware.]''' | ||
| + | |||
| + | |||
==Replacing the Viki LCD display board== | ==Replacing the Viki LCD display board== | ||
| Line 23: | Line 29: | ||
| − | [[File:Viki replace.jpg|200px|thumb|left| Viki Case | + | [[File:Viki replace.jpg|200px|thumb|left| Viki Case]] |
| − | + | ||
| − | + | ||
Latest revision as of 22:44, 2 February 2016
Viki Case
Download our Viki Holder model here to print it yourself
...and use our PDF instruction manual:
Upgrading from a Viki 1 to a Viki 2 requires you to install new firmware.
Replacing the Viki LCD display board
- Remove the four screws securing the aluminum LCD enclosure end plate with the cable grommet.
- Slide out the enclosure plate with the Viki attached.
- Note orientation and location of two wire bundles.
- Unplug cables from old unit and plug into new one
- Remove M3 screws fixing the old Viki to the cover plate
- Replace old Viki with new one
- Reassemble and test unit
re:3D wiring for Azteegs 1.0 through 2.0
