Difference between revisions of "Viki installation"
From re:3D
(4 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
==Viki Case== | ==Viki Case== | ||
[[File:Viki_holder.jpg|400px|right]] | [[File:Viki_holder.jpg|400px|right]] | ||
− | + | ||
− | [[File:Viki_holder3_rotated.stl]] | + | |
+ | [https://sketchfab.com/models/52953fee13ac4e9292c63c8bb65dfa3c Download our Viki Holder model here to print it yourself] | ||
+ | |||
+ | <!---Download the printed Viki Holder here: [[File:Viki_holder3_rotated.stl]]---> | ||
+ | |||
+ | ...and use our PDF instruction manual: | ||
+ | [[Image:Viki_2_Manual.jpg|thumb|none|top|500px|link=http://wiki.re3d.org/images/8/8a/Re3D_Viki_2_Full_10-21-2015.pdf]] | ||
+ | |||
+ | |||
+ | |||
+ | '''Upgrading from a Viki 1 to a Viki 2 requires you to install new [http://wiki.re3d.org/index.php?title=Firmware_installation firmware.]''' | ||
+ | |||
Line 15: | Line 26: | ||
#Reassemble and test unit | #Reassemble and test unit | ||
− | [ | + | '''[http://wiki.re3d.org/images/5/52/Viki_2.0_Wiring.pdf re:3D wiring for Azteegs 1.0 through 2.0]''' |
+ | |||
− | [[File: | + | [[File:Viki replace.jpg|200px|thumb|left| Viki Case]] |
Latest revision as of 22:44, 2 February 2016
Viki Case
Download our Viki Holder model here to print it yourself
...and use our PDF instruction manual:
Upgrading from a Viki 1 to a Viki 2 requires you to install new firmware.
Replacing the Viki LCD display board
- Remove the four screws securing the aluminum LCD enclosure end plate with the cable grommet.
- Slide out the enclosure plate with the Viki attached.
- Note orientation and location of two wire bundles.
- Unplug cables from old unit and plug into new one
- Remove M3 screws fixing the old Viki to the cover plate
- Replace old Viki with new one
- Reassemble and test unit
re:3D wiring for Azteegs 1.0 through 2.0