Difference between revisions of "Viki installation"
From re:3D
Line 4: | Line 4: | ||
Download the printed Viki Holder here: [[File:Viki_holder3_rotated.stl]] | Download the printed Viki Holder here: [[File:Viki_holder3_rotated.stl]] | ||
− | . | + | ...and use our PDF instruction manual: |
− | [[ | + | [[Image:Viki_2_Manual.jpg|thumb|none|top|500px|link=http://wiki.re3d.org/images/8/8a/Re3D_Viki_2_Full_10-21-2015.pdf]] |
==Replacing the Viki LCD display board== | ==Replacing the Viki LCD display board== | ||
Line 16: | Line 16: | ||
#Replace old Viki with new one | #Replace old Viki with new one | ||
#Reassemble and test unit | #Reassemble and test unit | ||
+ | |||
+ | '''[http://wiki.re3d.org/images/5/52/Viki_2.0_Wiring.pdf re:3D wiring for Azteegs 1.0 through 2.0]''' | ||
+ | |||
[[File:Viki replace.jpg|200px|thumb|left| Viki Case]] | [[File:Viki replace.jpg|200px|thumb|left| Viki Case]] | ||
[[File:Viki_wiring_to_azteeg.jpeg|800px|left]] | [[File:Viki_wiring_to_azteeg.jpeg|800px|left]] |
Revision as of 14:55, 17 November 2015
Viki Case
Download the printed Viki Holder here: File:Viki holder3 rotated.stl
...and use our PDF instruction manual:
Replacing the Viki LCD display board
- Remove the four screws securing the aluminum LCD enclosure end plate with the cable grommet.
- Slide out the enclosure plate with the Viki attached.
- Note orientation and location of two wire bundles.
- Unplug cables from old unit and plug into new one
- Remove M3 screws fixing the old Viki to the cover plate
- Replace old Viki with new one
- Reassemble and test unit
re:3D wiring for Azteegs 1.0 through 2.0