Difference between revisions of "Fully Assembled Gigabot"
From re:3D
(→Check bed height and bed level) |
|||
Line 22: | Line 22: | ||
#Home Z and check bed height | #Home Z and check bed height | ||
##Very important. The first layer of your print is the foundation of your object. The hot end tip should be about 0.005" above the bed | ##Very important. The first layer of your print is the foundation of your object. The hot end tip should be about 0.005" above the bed | ||
− | + | #Check bed level | |
− | + | ##Manually move the print head front to back and right to left over the bed | |
− | #Manually move the print head front to back and right to left over the bed | + | |
===Installing software and start printing=== | ===Installing software and start printing=== |
Revision as of 18:41, 19 March 2016
Contents
Gigabot Quick Start Guide
Receiving and uncrating
- Check the exterior of the crate for any visible damage
- Inspect the Tip-n-Tell indicators on two sides of the crate
- Inspect Shockwatch indicator on the outside of the crate
Open crate and remove Gigabot
- Remove bed locks and zip ties.
Check bed height and bed level
- Plug in power
- Turn on Gigabot
- Home Z and check bed height
- Very important. The first layer of your print is the foundation of your object. The hot end tip should be about 0.005" above the bed
- Check bed level
- Manually move the print head front to back and right to left over the bed