Difference between revisions of "Fully Assembled Gigabot"
From re:3D
(→Check bed height and bed level) |
(→Gigabot Quick Start Guide) |
||
Line 2: | Line 2: | ||
===Receiving and uncrating=== | ===Receiving and uncrating=== | ||
− | # | + | #Check the exterior of the crate for any visible damage |
#Inspect the Tip-n-Tell indicators on two sides of the crate | #Inspect the Tip-n-Tell indicators on two sides of the crate | ||
#Inspect Shockwatch indicator on the outside of the crate | #Inspect Shockwatch indicator on the outside of the crate |
Revision as of 04:47, 19 March 2016
Contents
Gigabot Quick Start Guide
Receiving and uncrating
- Check the exterior of the crate for any visible damage
- Inspect the Tip-n-Tell indicators on two sides of the crate
- Inspect Shockwatch indicator on the outside of the crate
Open crate and remove Gigabot
- Remove bed locks and zip ties.
Check bed height and bed level
- Plug in power
- Turn on Gigabot
- Home Z and check bed height
Very important. The first layer of your print is the foundation of your object
- Hot end tip should be about 0.005" above the bed
Check bed level
- Manually move the print head front to back and right to left over the bed