Difference between revisions of "Fully Assembled Gigabot"
From re:3D
(→Installing software and start printing) |
|||
Line 9: | Line 9: | ||
#[[Installing and using software with Gigabot]] | #[[Installing and using software with Gigabot]] | ||
+ | #[[Firmware installation]] | ||
#[[Calibrating your Gigabot]] | #[[Calibrating your Gigabot]] | ||
#[[First Print]] | #[[First Print]] |
Revision as of 22:54, 27 October 2015
Contents
Fully assembled Gigabot
Opening the crate and setting up your Gigabot
- Inspect the exterior of the crate for any visible damage
- Inspect the Tip-n-Tell indicators on two sides of the crate
- Inspect Shockwatch indicator on the outside of the crate
Installing software and start printing
- Installing and using software with Gigabot
- Firmware installation
- Calibrating your Gigabot
- First Print