Difference between revisions of "Fully Assembled Gigabot"

From re:3D
Jump to: navigation, search
(Check bed height and bed level)
(Gigabot Quick Start Guide)
 
(8 intermediate revisions by 2 users not shown)
Line 1: Line 1:
 
==Gigabot Quick Start Guide==
 
==Gigabot Quick Start Guide==
 
+
[[Image:Quickstartguide.png|thumb|none|top|400px|link=https://drive.google.com/file/d/1jRjjoBT8OyVUEhp0CKJQafOpoOXnFTXJ/view?usp=sharing|alt=Alt text|Gigabot Quick Start Guide]]
===Receiving and uncrating===
+
#Inspect the exterior of the crate for any visible damage
+
#Inspect the Tip-n-Tell indicators on two sides of the crate
+
#Inspect Shockwatch indicator on the outside of the crate
+
 
+
[[File:Tipntell.jpg|left|300]]
+
[[File:Shockwatch.jpg|center|300]]
+
 
+
 
+
[[Image:Gb_crate.jpg|none|300px|alt=Alt text|]]  
+
Open crate and remove Gigabot
+
 
+
 
+
#Remove bed locks and zip ties.
+
 
+
 
+
===Check bed height and bed level===
+
#Plug in power
+
#Turn on Gigabot
+
#Home Z and check bed height
+
====Very important. The first layer of your print is the foundation of your object====
+
#Hot end tip should be about 0.005" above the bed
+
 
+
===Check bed level===
+
#Manually move the print head front to back and right to left over the bed
+
  
 
===Installing software and start printing===
 
===Installing software and start printing===
  
 
#[[Installing and using software with Gigabot]]
 
#[[Installing and using software with Gigabot]]
#[[Calibrating your Gigabot]]
 
 
#[[First Print]]
 
#[[First Print]]
  

Latest revision as of 20:44, 30 October 2018

Gigabot Quick Start Guide

Alt text
Gigabot Quick Start Guide

Installing software and start printing

  1. Installing and using software with Gigabot
  2. First Print

Getting the most from your Gigabot

  1. Getting a good print
  2. Printing from Gigabot's Viki controller
  3. Tuning hot-end temperature controller
  4. Changing the filament spool
  5. Gigabot maintenance schedule