|
|
(3 intermediate revisions by one other user not shown) |
Line 1: |
Line 1: |
| ==Gigabot Quick Start Guide== | | ==Gigabot Quick Start Guide== |
− | | + | [[Image:Quickstartguide.png|thumb|none|top|400px|link=http://wiki.re3d.org/images/5/54/GB3%2B_Quick_Start.pdf|alt=Alt text|Gigabot Quick Start Guide]] |
− | ===Receiving and uncrating===
| + | |
− | #Check the exterior of the crate for any visible damage
| + | |
− | #Inspect the Tip-n-Tell indicators on two sides of the crate
| + | |
− | #Inspect Shockwatch indicator on the outside of the crate
| + | |
− | | + | |
− | [[File:Tipntell.jpg|left|300]] | + | |
− | [[File:Shockwatch.jpg|center|300]]
| + | |
− | | + | |
− | | + | |
− | [[Image:Gb_crate.jpg|none|300px|alt=Alt text|]]
| + | |
− | Open crate and remove Gigabot
| + | |
− | | + | |
− | | + | |
− | #Remove bed locks and zip ties.
| + | |
− | | + | |
− | | + | |
− | ===Check bed height and bed level===
| + | |
− | #Plug in power
| + | |
− | #Turn on Gigabot
| + | |
− | #Home Z and check bed height
| + | |
− | ##Very important. The first layer of your print is the foundation of your object. The hot end tip should be about 0.005" above the bed
| + | |
− | #Check bed level
| + | |
− | ##Manually move the print head front to back and right to left over the bed
| + | |
− | | + | |
− | ===Load filament===
| + | |
− | #Place roll on spool holder
| + | |
− | #Filament loaded in extruder
| + | |
| | | |
| ===Installing software and start printing=== | | ===Installing software and start printing=== |