Difference between revisions of "Fully Assembled Gigabot"
From re:3D
(→Gigabot Quick Start Guide) |
(→Check bed height and bed level) |
||
Line 21: | Line 21: | ||
#Turn on Gigabot | #Turn on Gigabot | ||
#Home Z and check bed height | #Home Z and check bed height | ||
− | + | ##Very important. The first layer of your print is the foundation of your object. The hot end tip should be about 0.005" above the bed | |
− | + | ||
===Check bed level=== | ===Check bed level=== |
Revision as of 18:40, 19 March 2016
Contents
Gigabot Quick Start Guide
Receiving and uncrating
- Check the exterior of the crate for any visible damage
- Inspect the Tip-n-Tell indicators on two sides of the crate
- Inspect Shockwatch indicator on the outside of the crate
Open crate and remove Gigabot
- Remove bed locks and zip ties.
Check bed height and bed level
- Plug in power
- Turn on Gigabot
- Home Z and check bed height
- Very important. The first layer of your print is the foundation of your object. The hot end tip should be about 0.005" above the bed
Check bed level
- Manually move the print head front to back and right to left over the bed