Firmware installation

From re:3D
Revision as of 21:48, 4 August 2014 by Matthew (Talk | contribs)

Jump to: navigation, search

Software

We recommend using Arduino IDE version 1.0.5 to load the firmware into Gigabot's brain (aka Azteeg X3 controller board).

There are two versions of the firmware:

You will also need the supporting libraries for the LCD display: Arduino Sketchbook.zip

Configuring and compilation

  • Install the Arduino software
  • Unzip the Arduino Sketchbook.zip
  • Open Arduino and go to File-> Preferences. Under "Sketchbook Location" click on Browse. Navigate to the Arduino Sketchbook folder you unzipped above


Start the arduino IDE. Select Tools -> Board -> Arduino Mega 2560 or your microcontroller Select the correct serial port in Tools ->Serial Port Open Marlin.pde

Click the Verify/Compile button

Click the Upload button If all goes well the firmware is uploading